Principal designers: Back to basics for installing a new gate

Principal designers: Back to basics for installing a new gate

When you are considering installing a new gate – automatic or manual – it is important to design out any hazards so there are a number of considerations to bear in mind.

  • Is the ground / road leading to and from the gate level?
  • Are there any obstructions which the gate might open against?
  • What type of gate will deliver the safest and most effective means of protection?
  • How will the gate be made? Do any of the hinges create potential pinch points? Does the infill represent a potential trap point?

When the type of gate has been identified and the entrance landscaping or fencing also agreed upon, the overall strength of the installation needs to be addressed. Are the foundations commensurate with the weight of the gate? Are the gate posts sufficiently robust? Does the gate require any stops or brackets to prevent it falling?

If the gate in mind is to be operated manually, thought should be given to how easy it will be to move the gate. The accepted norm is that the gate should never need more than 26kg (260 newtons) to operate safely. Be aware that wind factors will dramatically increase the load on a swing gate.

If you elect to install an automated gate you will need to consider how the gate is to be operated. Will it be a hold to run or a fully automated installation? The choice of safety devices will be influenced by the mode of operation but will typically include safety edges and photocells.

The control equipment will need to be connected to the electrical mains supply by a suitably qualified (17th edition) electrician to ensure compliance with current industry guidance.

Once the gate has been installed, it is vital that the gate user / owner is encouraged to regularly inspect the device to check for wear & tear / the safe operation of the gate. Formal maintenance by either the original installer or an alternative maintenance company should be conducted every six-months as a minimum.

If you are unsure how to achieve any of the above, it’s time to contact a Gate Safe installer, visit the Gate Safe website to find the installer closest to you,

Back to main page

Gate Safe
Beverlea, Clavertye,
Elham, Canterbury
Kent. CT4 6YE

Stacks Image p48_n18

Working together with Gate Safe

Gate Safe is a registered charity in England and Wales (no 1149261).

Gate Safe and the Gate Safe logo are registered trade marks of GSSC Ltd.

The guidance and recommendations on this website represent our interpretation of advice based on information from HSE, British Standards and relevant UK legislation. It is not a definitive statement and should be used in conjunction with your own risk assessment of the specific site prior to undertaking any works. GSSC Ltd take no responsibility for any works carried out by the Gate Safe Aware Installers or for any installations carried out using the information and advice given on this website. All content, trade marks, downloads and images are copyright Gate Safe GSSC Ltd

Website by Kikk |